Pregled bibliografske jedinice broj: 997518
Cutting forces in interrupted hard turning
Cutting forces in interrupted hard turning // Proceedings of TEAM 2018 9th international Scientific and expert conference / Lalić, Bojan (ur.).
Novi Sad: Faculty of technical sciences Novi Sad, 2018. str. 128-133 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), ostalo)
CROSBI ID: 997518 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Cutting forces in interrupted hard turning
Autori
Smojvir, Denis ; Duspara, Miroslav ; Stoić Katarina ; Stoić, Antun ; Stoić, Marija
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), ostalo
Izvornik
Proceedings of TEAM 2018 9th international Scientific and expert conference
/ Lalić, Bojan - Novi Sad : Faculty of technical sciences Novi Sad, 2018, 128-133
ISBN
978-86-6022-098-3
Skup
9th International Scientific and Expert Conference (TEAM 2018)
Mjesto i datum
Novi Sad, Srbija, 10.10.2018. - 12.10.2018
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
FEM, cutting tool, deformation, optimisation
Sažetak
The paper presents the parameters that determine the variability of the cutting conditions in the turning process. The experimental results are given for the measurement of the cutting forces during turning of steel Č 1530. The experiment was done on the TNP 160 Prvomajska turning machine using insert CNMG 120408 HA. The insert was clamped into the PCLNL 3225M12 tool holder. Three 120-mm HBM sensors (measuring strips) are connected to the MGCPlus measuring device with an A / D transducer from the cable holder. Values of force components are calculated in relation to the deformation shown by the metering strip.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
POVEZANOST RADA
Projekti:
302
Ustanove:
Strojarski fakultet, Slavonski Brod,
Veleučilište u Slavonskom Brodu
