Pregled bibliografske jedinice broj: 98389
A Bipolar Charge Measurement Szstem for Aerosol Characterization
A Bipolar Charge Measurement Szstem for Aerosol Characterization // Conference Recird on IEEE-IAS Annual Meeting
St. Louis: Institute of Electrical and Electronics Engineers (IEEE), 1998. str. 1967-1971 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 98389 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
A Bipolar Charge Measurement Szstem for Aerosol Characterization
Autori
Hrabar, Silvio ; Balachandran, Wamadeva ; Machowski, Woichech
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Conference Recird on IEEE-IAS Annual Meeting
/ - St. Louis : Institute of Electrical and Electronics Engineers (IEEE), 1998, 1967-1971
Skup
Industrial Applications Conferernce 1998
Mjesto i datum
Sjedinjene Američke Države, 12.10.1998. - 15.10.1998
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
aerosol characterization; bipolar charge; measurement system
(precipitation)
Sažetak
This paper reports the development of a bipolar charge measurement system for aerosol characterization. The system incorporates a front-end cylindrical arrangement consisting of two 'D' shaped precipitation sections. Each of these sections incorporates wire electrodes maintained at a high potential of opposite polarity. The interface between the two 'D' sections is thin wedge, the front of which acts as a bifurcation for the incoming aerosol. The test aerosol is drawn through the bifurcation separator using a suction pump, and subject to an appropriate electric field. Depending on the electric field distribution and air-flow characteristics, particles of the same polarity as the potential applied to the wire electrodes are deflected toward an outer collecting wall and give up their charge. This precipitation section is connected to a series of five 'D' shaped electrodes (open-ended Faraday chambers) to collect the charged aerosol of different charge to mass ratio. Both analytical and numerical calculations were performed to optimize the design of the manufactured system. Preliminary tests were carried out with an aerosol of known size and charge distribution. The results obtained are in good agreement with theoretical predictions.
Izvorni jezik
Engleski
Znanstvena područja
Elektrotehnika
POVEZANOST RADA
Projekti:
036028
Ustanove:
Fakultet elektrotehnike i računarstva, Zagreb
Profili:
Silvio Hrabar
(autor)