Naslov
The laboratory testing of steel 20MnCr5

Autori
Opačak, Ivan ; Marić, Alen ; Dašić, Predrag ; Marušić, Vlatko

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the XV International scientific congress winter session MACHINЕS. TECHNOLОGIES. MATERIALS 2018 / Popov, Georgi - Sofija : Scientific technical union of mechanical engineering Industry - 4.0, 2018, 136-139

Skup
XV International Scientific Congress: Machines. Technologies. Materials

Mjesto i datum
Borovec, Bugarska, 14.03.2018. - 17.03.2018

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
steel 20MnCr5 ; microstructures ; hardnesses ; adhesion wear

Sažetak
In this paper the laboratory tests on the selected steel for cementation 20MnCr5 was perfomed. The influence of the contact load resistance to the adhesion wear of high-temperature carbonitrided MnCr steels was analyzed. As a representative example was selected a tribosystem drive/driven gear of reducers in which are expressed high contact loads. For the purposes of these tests, the samples were first high-temperature carbonitrided, and then they are carried to the appropriate chemical and metallographic analysis, control of the surface hardnesses and the resistance to the adhesion wear. The aim of this paper was to observe the representative tribosystem as much possible to define its working parameters in order to determine the optimum conditions for testing the influence of the contact load on resistance to the adhesion wear. The analysis results show that high-temperature carbonitrided steel where the atmosphere of furnace at the beginning of carburizing was enriched with nitrogen, and finally with carbon showed significantly greater resistance to the adhesion wear compared to steel that at the beginning of carburizing had atmosphere of furnace rich in carbon, and finally with nitrogen.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA