Naslov
Parametrization and Calculation of a Shaft by Using Mathematical Applications

Autori
Kerin, Matija ; Tevčić, Marina ; Kotarski, Denis

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
16th INTERNATIONAL SCIENTIFIC CONFERENCE ON PRODUCTION ENGINEERING – CIM2017 - Croatian Association of Production Engineering / Abele, Eberhard ; Udiljak, Toma ; Ciglar, Damir - Zagreb : Hrvatska udruga proizvodnog strojarstva (HUPS), 2017, 149-154

Skup
16th INTERNATIONAL SCIENTIFIC CONFERENCE ON PRODUCTION ENGINEERING – CIM2017 - Croatian Association of Production Engineering

Mjesto i datum
Zadar, Hrvatska, 08.06.2017. - 10.06.2017

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Mathcad, CATIA, shaft, reducer, gear, parametric design.
(Mathcad, CATIA, shaft, reducer, gear, parametric design)

Sažetak
It is advisable to carry out parametric calculation and make parametric 3D model for machine parts which undergo frequent changes of initial applications of both the structure and the load. It was found that designers spend most of their time adapting the existing models. This paper presents an example of calculation of gear reducer shaft. The parametric calculation model was done in the programme Mathcad, and then the tool "Excel component" was used to transfer the calculated data in an Excel spread sheet. The spread sheet was loaded using the "Design Table" in the parametric 3D model in CATIA programme. On the basis of loaded parameters a new model was produced. The advantages of this construction approach are the reduction of time as well as the reduction of errors that can occur when carrying out the calculation.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA