Naslov
Kerf Variation Analysing After Cutting With Abrasive Water Jet of a Steel Part

Autori
Basarman, A.P. ; Damjanovic, D. ; , Kozak, D. ; Lobonțiu, M. ; Medan, N.

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 8th International Scientific and Expert Conference TEAM 2016 / Maronek, Milan ; Barta Jozef - Trnava : Alumni Press, 2016, 211-217

ISBN
978-80-8096-237-1

Skup
8th International Scientific and Expert Conference TEAM 2016

Mjesto i datum
Trnava, Slovačka, 19.10.2016. - 21.10.2016

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Abrasive Water Jet; Surface Quality; Surface Aspect; Kerf; Taper

Sažetak
The method of cutting materials using water jet is a method that is in full ascension regarding the level of usability in production. In order to have the adequate setup for water jet cutting on a certain system, the surface quality, the kerf aspect, the shape and respectively the form of the obtained part have to be researched and analyzed.This paper presents the results obtained after cutting one square shaped part, made of 1C45 material. In the study was analised both the inside and the outside of the cut, the kerf width, the aspect of the taper and the profile deviation.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA