Naslov
Influence of Microstructure of 65Si7 Steel on its Mechanical Properties

Autori
Pustaić, Dragan ; Cajner, Franjo

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni

Izvornik
ABSTRACT BOOKLET - MSMF6 ; MATERIALS STRUCTURE & MICROMECHANICS OF FRACTURE - MSMF6 / Šandera, Pavel - Brno : VUTIUM Brno, 2010, 119-119

ISBN
978-80-214-4112-5

Skup
The 6th International Conference on MATERIALS STRUCTURE & MICROMECHANICS OF FRACTURE - MSMF6

Mjesto i datum
Brno, Češka Republika, 28.06.2010. - 30.06.2010

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Heat treatment procedures; Hardening and tempering; Austempering; Mechanical properties; Toughness; Strength; Hardness; Fatigue strength; Fracture mechanics parameters; Stress intensity factor

Sažetak
Introduction. The aim of the performed investigations was to determine the influence of two different heat treatment procedures, i. e. hardening and tempering vs. austempering, on some mechanical and fracture properties of a particular type of steel (steel 65Si7 ; the chemical composition: 0.69% C, 1.56% Si and 0.90% Mn). An advantage of austempering over hardening and tempering is in obtaining the bainite microstructure which has greater toughness, ductility, contraction, fatigue strength and a better fracture toughness than a tempered martensite of the same type of steel [2, 3]. All these advantages of bainite refer to untempered state. By tempering of bainite microstructure steel its toughness decreases and in tempered bainite it is lower than the toughness of temepered martensite [3]. Since the researches aimed to investigate the influence of various microstructural states of steel on its properties, the specimens were first submitted to heat treatment. After heat treatment, photographs of microstructures of the starting conditions (prior to tempering) were taken. From the photos it is clearly seen that the specimens had two different microstructures: • by cooling down in oil the obtained microstructure was a hardened microstructure with visible plates of martensite, and its hardness was 850 HV1, • by austempering the obtained microstructure was a microstructure of lower bainite metal base, with probably lower share of residual austenite and with hardness of 440 HV1. Crack mouth opening displacement (CMOD) in dependence of the load on the specimen is measured. The measured values are recorded in the form of a diagram F-CMOD, Fig.1., BS 7448. Fig. 1. Dependence of crack mouth opening displacement CMOD on the force F, a) for hardened and tempered specimens, b) for austempered specimens, untempered and tempered References [1] Pustaić, D. and Cajner, F., Inžynieria materialowa, vol. 5 (124), (2001), 733-736. [2] Cajner, F., Strojarstvo, J. Theo. Apl. Mech. Engng., vol. 33 (5/6), (1991), 289-296. [3] Cajner, F., Kovine, zlitine, tehnologije, vol. 28 (6), (1994), 533-538.

Izvorni jezik
Engleski

Znanstvena područja
Brodogradnja, Strojarstvo, Zrakoplovstvo, raketna i svemirska tehnika

POVEZANOST RADA