Naslov
EFFECT OF ANTI-WEAR ADDITIVE ON CUTTING TOOL AND SURFACE LAYER OF WORKPIECE STATE UNDER MQCL CONDITIONS

Autori
Maruda, Radoslaw ; Legutko, Stanislaw ; Krolczyk, Grzegorz ; Lukianowicz, Czeslaw ; Stoić, Antun

Izvornik
Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku (1330-3651) 53 (2015), 2; 1219-1223

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Anti-Wear additives; MQCL; stainless steel; surface roughness; turning

Sažetak
The work presents the results of investigation of the influence of anti-wear additive Crodafos EHA-LQ-(MH) added to the emulsion mist on the condition of machined surface of 1.4310 stainless steel after turning. The investigation included the comparison of the following cutting conditions: dry machining, cooling by the MQCL method and cooling by the MQCL method with Crodafos EHA-LQ-(MH). In the paper, the influence of the Anti-Wear (AW) additive on the roughness parameter Ra of the machined surface for various cutting speeds, vc, and mass flow of the emulsion E has been shown. It was found that the MQCL+AW method decreases the Ra parameter values by 14 % to 35 % in comparison with dry cutting and by 17 % in comparison with MQCL method.The machined material and the rake face of the cutting wedge have been subjected to micro X-ray spectroanalysis. Chemical analysis of the cutting wedge and the surface layer of the machined material has been performed. The results show that water dropletts in MQCL method are very good transport facility for active compounds of AW additive that consequently form the dry-film lubricant on the machined surface.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA