Pregled bibliografske jedinice broj: 810009
Ablative potential of Er:YAG laser: quantum square pulse mode versus new digitally controlled dental laser handpiece (X-runner)
Ablative potential of Er:YAG laser: quantum square pulse mode versus new digitally controlled dental laser handpiece (X-runner) // Journal of Dental Research
Antalya, Turska, 2015. (poster, međunarodna recenzija, neobjavljeni rad, znanstveni)
CROSBI ID: 810009 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Ablative potential of Er:YAG laser: quantum square
pulse mode versus new digitally controlled dental
laser handpiece (X-runner)
Autori
Miletić, Ivana ; Nathanson, Dan ; Gabrić, Dragana ; Matijević, Jurica ; Baraba, Anja
Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, neobjavljeni rad, znanstveni
Izvornik
Journal of Dental Research
/ - , 2015
Skup
47 meeting of CED IADR 2015
Mjesto i datum
Antalya, Turska, 15.10.2015. - 17.10.2015
Vrsta sudjelovanja
Poster
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
Er:YAG laser ; ablation rate ; x-Runner
Sažetak
Objectives: The primary objective of this in vitro study was to compare ablated volume and dentin ablation rate of quantum square pulse (QSP), using two different pulse energy settings, and a new digitally controlled dental laser handpiece (X- runner) in QSP mode. The secondary objective was to examine the effects of the ablation with different Er:YAG laser modes on dentin surface using SEM. Methods: Freshly extracted human molars (n=36) were divided into three experimental groups. Cavity preparations were made in dentinas follows: 1) QSP with pulse energy of 250 mJ ; 2) QSP with pulse energy of 500 mJ and 3) X-runner in QSP mode with pulse energy of 250 mJ, at time intervals of 1, 2 and 5 seconds. A laser triangulation profilometer was used to determine cavity volumes and SEM analysis was performed to examine the surface of cavity preparation surfaces in all experimental groups. Results: There was asignificant difference in ablated volume and ablation rate for QSP (pulse energy 250 mJ) and X- runner groups and between QSP (pulse energy 500 mJ) vs. QSP mode (pulse energy 250 mJ) for all examined time periods (p<0.05). There was no significant difference in ablated volume and ablation rate between X-runner and QSP mode (pulse energy 500 mJ), (p>0.05). In all laser groups, except the group where X- runner was used, dentin surface was free of smear layer, exhibiting open dentinal tubules. Conclusions: A larger volume of dentin was removed and with higher ablation rate in X-runner group in comparison to QSP mode with pulse energy of 250 mJ. There was no difference in ablated volume and ablation rate between X- runner and QSP mode with pulse energy of 500 mJ. Out of all the examined laser groups, only the X-runner group exhibited smear layer and closed dental tubules in the SEM analysis.
Izvorni jezik
Engleski
Znanstvena područja
Dentalna medicina
POVEZANOST RADA
Ustanove:
Stomatološki fakultet, Zagreb