Naslov
Comparison of results obtained using Coordinate Measuring Machine, Computed Radiography and Computed Tomography

Autori
Katić, Marko ; Baršić, Gorana ; Mihaljević, Morana

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
6th Conference on Industrial Computed Tomography / Johann Kastner - Wels : University of Applied Sciences Upper Austria, 2016, 132-134

Skup
Annual Meeting on Computed Tomography

Mjesto i datum
Wels, Austrija, 09.02.2016. - 12.02.2016

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
dimensional measurements; Coordinate Measuring Machine; Computed Tomography; Computer Radiography

Sažetak
Dimensional measurements of a multimaterial sample have been performed using three different measurement methods (instruments): Coordinate Measuring Machine (CMM), Industrial Computed Tomography (CT) and Computed Radiography (CR). The sample was measured at Department of Quality, Faculty of mechanical engineering and naval architecture in two laboratories: Croatian National Laboratory for Length and in Laboratory for non-destructive testing. Comparison of measurement results obtained using these three instruments is a fundamental part of the research on measurement capabilities of CT and CR. Preliminary research revealed satisfactory capabilities for broad industrial applications but still there are obtainable opportunities to improve CR and CT measurement capabilities and resolve specific difficulties.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA