Naslov
Application of the milling machine vibration signal for cutter condition monitoring

Autori
Hnatko, Emil ; Majdandžić, Niko ; Ergić, Todor ; Stoić, Antun ; Šarić, Tomislav ; Jozić, Marko ; Tadijanović, Adam

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 1st DAAAM International Conference on Advanced Technologies for Developing Countries / Katalinić, B ; Kljajin, Milan - Slavonski Brod : DAAAM International Vienna ; Strojarski fakultet Sveučilišta u Slavonskom Brodu, 2002, 483-488

Skup
Advanced Technologies for Developing Countries

Mjesto i datum
Slavonski Brod, Hrvatska, 12.09.2002. - 14.09.2002

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
vibration signal; tool wear; milling machine; measurement

Sažetak
The results of a wide scale vibration measurements conducted on a milling machine (E. Hnatko et al. CIM ‘99 ; E. Hnatko et al. CIM 2000) have established a clear influence of certain parameters on the behaviour of the vibration signal. The measurements were conducted by the Mechanical Engineering Faculty in Slavonski Brod. This paper presents the results of researching the influence of the working milling machine parameters on the vibration and the vibration signal usage as a diagnostic parameter for cutter condition monitoring. In order to keep the results comparable to the previous ones some of the working parameters were kept the same, eg. tool geometry, cutting speed, material and geometry of the workpiece. An important part of the research was tool wear during the work of the milling machine.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA