Naslov
The relation between the sound pressure and tool vibrations during the turning process

Autori
Kopač, Janez ; Stoić, Antun ; Šali, Samo ; Samardžić, Ivan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 8th International Conference on production engineering / Cebalo R., Schulz H. - Zagreb : Hrvatska udruga proizvodnog strojarstva (HUPS), 2002, I 081- I 091

Skup
8th International Conference on production engineering CIM 2002

Mjesto i datum
Brijuni, Hrvatska, 13.06.2002. - 14.06.2002

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
turning; monitoring; noise; acceleration

Sažetak
The aim of our research was a comparison of two different signals (sound pressure near the cutting zone and tool vibrations) during the turning process. It was assumed and confirmed that each group of signals has its advantages and limitations. The measurements were performed on a heat treatable steel Č1431, whereas CBN inserts were used during dry cutting. Noise and acceleration data were recorded and analysed in frequency range between 1 to 20 kHz. An influence of cutting speed and insert radius on both groups of signals was observed. The results showed that a high possibility in terms of process monitoring exists for both groups of signals, especially for a large-scale production.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA