Naslov
Identification of cutting conditions in turning by noise recording

Autori
Raos, Pero ; Stoić, Antun ; Kopač, Janez

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 1st DAAAM International Conference on Advanced Technologies for Developing Countries / Katalinić B. & Kljajin M. - Slavonski Brod : DAAAM International Vienna ; Strojarski fakultet Sveučilišta u Slavonskom Brodu, 2002, 527-532

Skup
Advanced Technologies for Developing Countries ATDC'02

Mjesto i datum
Slavonski Brod, Hrvatska, 12.09.2002. - 14.09.2002

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
turning parameters; monitoring; noise

Sažetak
The aim of the present research was to identify and predict the influence of the cutting conditions on noise during the turning process. Therefore, the sound pressure at 0, 5 m from the cutting zone during the turning was measured by the condenser microphone and analysed in frequency domain from 0 to 20 kHz. The possibilities for on-line sensing of the tool wear are presented. The results shows influence of cutting speed, feed rate, nose radius and tool wear on noise during turning.It was concluded that under the given circumenstances the identification of the turning process by the sound is possible, and relatively simple method for large scale application.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA