Naslov
Optimization of the roughness of the grinded surface by tool dressing with the diamond roll

Autori
Cebalo, Roko ; Stoić, Antun

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 1st DAAAM International Conference on Advanced Technologies for Developing Countries / Katalinić B.&Kljajin M. - Slavonski Brod : DAAAM International Vienna ; Strojarski fakultet Sveučilišta u Slavonskom Brodu, 2002, 155-160

Skup
Advanced Technologies for Developing Countries ATDC'02

Mjesto i datum
Hrvatska, 12.09.2002. - 14.09.2002

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
tool dressing; optimisation; roughness

Sažetak
Machining of the complex form surfaces was in the serial production, because of inapplicability of other machining technologies and because of necessity for achieving certain form accuracy and surface roughness, done by grinding in the past. This fact was valid until appearance of HSC that can substitute the grinding operation. Machining of the complex shapes with grinding is possible, until the grinder is dressing. The most frequently way of tool dressing is by using of diamond roll. Influence of tool dressing parameters on machined surface roughness, especially optimisation of the grinding speed in accordance with machined surface roughness, will be presented in this paper. Nevertheless, the optimisation of the grinding process in accordance with surface roughness and material removal rate will be also shown. Finally, the optimal regime of grinding will be determinate.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA