Pregled bibliografske jedinice broj: 76116
Comparison of surface topography obtained by high speed cutting and grinding
Comparison of surface topography obtained by high speed cutting and grinding // 8th International Scientific Conference on Production Engineering (CIM2002) / Cebalo, Roko ; Schulz, Herbert (ur.).
Zagreb, 2002. str. I-093 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 76116 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Comparison of surface topography obtained by high speed cutting and grinding
Autori
Mahović, Sanjin ; Udiljak, Toma ; Ciglar, Damir
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
8th International Scientific Conference on Production Engineering (CIM2002)
/ Cebalo, Roko ; Schulz, Herbert - Zagreb, 2002, I-093
Skup
International Scientific Conference on Production Engineering (8 ; 2002)
Mjesto i datum
Brijuni, Hrvatska, 13.06.2002. - 14.06.2002
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
grinding; high speed milling; surface roughness parameters
Sažetak
With high speed cutting, in particular high speed milling, it is possible to obtain the machined surfaces of a such quality that is, with classical approach, obtained by grinding. This paper presents the results of comparison of characteristics of machined surfaces belonging to the same surface roughness category, but obtained by two different machining processes, grinding and high speed milling. By comparing a number of parameters defining surface roughness and waviness, it is possible to answer if there are the differences in topography characteristics of the surfaces obtained by grinding and high speed milling that could influence tribological behavior of the surface.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
POVEZANOST RADA
Ustanove:
Fakultet strojarstva i brodogradnje, Zagreb
