Pregled bibliografske jedinice broj: 75232
Machinability at High Speed Orthogonal Turn-Milling
Machinability at High Speed Orthogonal Turn-Milling // International Scientific Conference on Production Engineering CIM'99 / Cebalo,Roko (ur.).
Zagreb: HUPS, 1999. (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 75232 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Machinability at High Speed Orthogonal Turn-Milling
Autori
Motika, Romano ; Škorić, Stephan ; Ciglar, Damir
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
International Scientific Conference on Production Engineering CIM'99
/ Cebalo,Roko - Zagreb : HUPS, 1999
Skup
International Scientific Conference on Production Engineering CIM'99
Mjesto i datum
Opatija, Hrvatska, 17.06.1999. - 18.06.1999
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
orthogonal turn-milling; machinability; surface roughness
Sažetak
The orthogonal turn-milling tends to replace turning as much as possible, because it has a lot of advantages in which the most important role belongs to higher productivity. Surface roughness is one of the basic machinability criteria. It also represents an advantage, especially in machining with high speed cutting. This article deals with the influence of some parameters on the surface roughness and also presents the mathematical model which describes this influence.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
