Pretražite po imenu i prezimenu autora, mentora, urednika, prevoditelja

Napredna pretraga

Pregled bibliografske jedinice broj: 673339

Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source


Rajković, Damir; Sentić, Mislav
Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source // Green design, materials and manufacturing processes : proceedings of the 2nd international conference on sustainable intelligent manufacturing / Bartolo, Helena et al. (ur.).
London : Delhi: CRC Press, 2013. str. 399-405 (poster, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


CROSBI ID: 673339 Za ispravke kontaktirajte CROSBI podršku putem web obrasca

Naslov
Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source

Autori
Rajković, Damir ; Sentić, Mislav

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Green design, materials and manufacturing processes : proceedings of the 2nd international conference on sustainable intelligent manufacturing / Bartolo, Helena et al. - London : Delhi : CRC Press, 2013, 399-405

ISBN
978-1138000469

Skup
2nd international conference on sustainable intelligent manufacturing

Mjesto i datum
Lisabon, Portugal, 26.06.2013. - 29.06.2013

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
COP, heat pump

Sažetak
Rational use and managing with energy is basic presumption of sustainable development. Economy with energy today is directed to using and promotion of pure technologies, with high energetic efficiency and using of renewable sources, and all in purpose of environmental protection. During the last decade heat pump technology has attracted increasing attention as one of the most promising technologies to save energy. Exactly, heat compressor pumps represent technology with high energetic efficiency. Heat pump is a device for moving heat from a low temperature heat source to a higher temperature heat sink using the power for compressor running. In most cases, electric engine runs the compressor. The efficiency of electric heat pump is defined with Coefficient Of Performance (COP – heating factor). It is defined as the ratio of heat delivered by the heat pump and the electric power for compressor running and auxiliaries. But, COP is not observed from primary energy source, it is observed after fuel energy transformation into electric energy (after primary energy transformation). In this article the electric heat pump running will be compared with the gas heat pump running from primary energy source (PER- primary energy ratio). PER is ratio between useful heating energy and primary energy. Gas heat pump uses a primary energy source without energy transformation and has got a lower CO2 emission. In this article, the major advantage of gas heat pump, the utilization of exhausted heat from gas engine (from cooling water and exhausted gases) will be described. Also, it will be described the two renewable heat sources: air and sea water with advantages and disadvantages.

Izvorni jezik
Engleski

Znanstvena područja
Rudarstvo, nafta i geološko inženjerstvo



POVEZANOST RADA


Projekti:
195-1951390-1398 - Racionalno korištenje energetskih mineralnih sirovina u Hrvatskoj (Rajković, Damir, MZOS ) ( CroRIS)

Ustanove:
Rudarsko-geološko-naftni fakultet, Zagreb

Profili:

Avatar Url Damir Rajković (autor)

Citiraj ovu publikaciju:

Rajković, Damir; Sentić, Mislav
Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source // Green design, materials and manufacturing processes : proceedings of the 2nd international conference on sustainable intelligent manufacturing / Bartolo, Helena et al. (ur.).
London : Delhi: CRC Press, 2013. str. 399-405 (poster, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
Rajković, D. & Sentić, M. (2013) Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source. U: Bartolo, H. (ur.)Green design, materials and manufacturing processes : proceedings of the 2nd international conference on sustainable intelligent manufacturing.
@article{article, author = {Rajkovi\'{c}, Damir and Senti\'{c}, Mislav}, editor = {Bartolo, H.}, year = {2013}, pages = {399-405}, keywords = {COP, heat pump}, isbn = {978-1138000469}, title = {Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source}, keyword = {COP, heat pump}, publisher = {CRC Press}, publisherplace = {Lisabon, Portugal} }
@article{article, author = {Rajkovi\'{c}, Damir and Senti\'{c}, Mislav}, editor = {Bartolo, H.}, year = {2013}, pages = {399-405}, keywords = {COP, heat pump}, isbn = {978-1138000469}, title = {Comparison of working (operating) efficiency of electric and gas heat pump regarding to renewable heat source}, keyword = {COP, heat pump}, publisher = {CRC Press}, publisherplace = {Lisabon, Portugal} }

Časopis indeksira:


  • Web of Science Core Collection (WoSCC)
    • Conference Proceedings Citation Index - Science (CPCI-S)
  • Scopus





Contrast
Increase Font
Decrease Font
Dyslexic Font