Naslov
Waste metallurgical materials - potential adsorbents for removal Cr6+

Autori
Glavaš, Zoran ; Štrkalj, Anita

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of 4th International Scientific Conference MOTSP 2012, Management of Technology Step to Sustainable Production / Ćosić, Predrag - Zagreb : Croatian Association for PLM (CAPLM), 2012, 1-5

Skup
4th International Scientific Conference MOTSP 2012, Management of Technology Step to Sustainable Production

Mjesto i datum
Zadar, Hrvatska, 14.06.2012. - 16.06.2012

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
waste metallurgical materials ; adsorption ; efficiency

Sažetak
This paper describes the use of three metallurgical waste materials (electric arc furnace slag, waste mould sand and waste steel shot after cleaning of castings) as adsorbents for removal of Cr6+ from aqueous solutions. The removal of Cr6+ was studied by batch tests. The obtained results show that the analyzed metallurgical waste materials are effective adsorbents for the removal of Cr6+ from aqueous solutions within the range of working concentrations. The rate of Cr6+ adsorption increased rapidly during the initial 60 minute. Comparing the all isotherms, electric arc furnace slag was shown higher adsorption of Cr6+ than other used waste metallurgical materials

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija

Napomena
Rad je objavljen u casopisu Acta technica corviniensis 6 (2013) (1) str. 81-84 ; ISSN 2067- 3809.

POVEZANOST RADA