Naslov
Finite Analysis of Deep Drawing Tool Geometry for Thin Walled Tin Can

Autori
Kršulja, Marko ; Štefančić, Mauro ; Car, Zlatan ; Pepelnjak, Tomaž ; Plančak, Miroslav ; Vojkovský, Karel

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
International Conference on Innovative Technologies IN-TECH / Car, Zlatan ; Kudláček, Jan ; Szalay, Tibor - Rijeka : Tehnički fakultet Sveučilišta u Rijeci, 2013, 401-404

ISBN
978-953-6326-88-4

Skup
International Conference on Innovative Technologies IN-TECH

Mjesto i datum
Budimpešta, Mađarska, 10.09.2013. - 13.09.2013

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
deep drawing; FEM; sheet metal; deformation; TS230; 1.0371

Sažetak
This investigation proposes modeling of new deep drawing tool geometry for thin sheet metal. TS230 (W. nr. 1.0371, T50HF) D2, 8/5, 60 41 ST/Fin thin walled (0.155 mm) material properties are investigated and results are put in numerical simulation. Tooling with influential parameters is modelled and analyzed with ABAQUS software. Minimum drawing force necessary for selected tool geometry and overall tool behaviour is investigated. Heat generation of selected tooling of deep draw process and its influence on thin sheet metal deformation is also considered. Optimization of process is achieved by elimination of errors that appear in form of wrinkling, excessive thinning or fracture.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija, Računarstvo, Strojarstvo

POVEZANOST RADA