Naslov
Investigation of Single Point Incremental Forming Process Applied on Thin Sheet Metal

Autori
Kršulja, Marko ; Kuzman ; Karl ; Plančak, Miroslav ; Math Miljenko ; Car, Zlatan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
International Conference on Innovative Technologies IN-TECH / Car, Zlatan ; Kudláček, Jan ; Pepelnjak, Tomaž ; - Rijeka : Tehnički fakultet Sveučilišta u Rijeci, 2012, 583-586

ISBN
978-953-6326-77-8

Skup
International Conference on Innovative Technologies IN-TECH

Mjesto i datum
Rijeka, Hrvatska, 26.09.2012. - 29.09.2012

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
SPIF; deep drawing; sheet metal forming; incremental; Solidcam

Sažetak
Single incremental metal forming SPIF and deep drawing process are similar technologies and SPIF can be used to build a prototype for additional analysis and later construction. In this paper the selection of parameters needed for SPIF process production with software Solidcam are shown. A consideration to strain hardening has been given. Experiment on a thin sheet metal TH435 CA ST E2.8/2.8 of 0.19 mm thickness has been conducted in order to understand basics of the technology.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija, Računarstvo, Strojarstvo

POVEZANOST RADA