Naslov
Microstructure and Mechanical Properties of Slip Cast Sol-Gel Derived Mullite Ceramics

Autori
Tkalčec, Emilija ; Nass, R. ; Krajewski, T. ; Rein, R. ; Schmidt, H.

Izvornik
Journal of the European Ceramic Society (0955-2219) 18 (1998), 8; 1089-1099

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Mullite; Microstructure; Creep; Bending strength at high temperature; ZrO_2 abrasion

Sažetak
Mullite ceramics were processed by pressureless sintering (1620 degrees C, 2 h) of slip cast mullite derived from single-phase gel calcined at 1070 degrees C and attrition milled with ZrO_2 balls. The four-point bending strength was determined from room temperature up to 1400 degrees C. Creep behaviour in compression was determined at stresses of 20 and 100 MPa and temperatures of 1200 to 1450 degrees C. Microstructural and microchemical characterisation of mullite material was performed using scanning (SEM) and high resolving transmission electron microscopy (HRTEM) in conjuction with energy dispersive X-ray spectrometry (EDX). A remarkable abrasion of ZrO_2, and the leaching of magnesium from ZrO_2 grains occurred in milling process. The bending strength and the creep behaviour is determined by residual glassy phase, observed in triple points and at the grain boundaries of mullite/mullite and mullite/ZrO_2 grains. When ZrO_2 grain participates in the formation of triple points, the composition of the glassy phase differs from that at the junction of three mullite grains. The EDX line microanalyses across the mullite/mullite grain boundaries revealed < 5 nm thick SiO_2-rich glassy film. There are some grain boundaries at which only a compositional gradient of SiO_2 occurred. The creep below 1300 degrees C is most likely controlled by grain boundary sliding accommodated by solution-precipitation mechanism, and above by the grain boundary sliding accommodated by viscous flow of SiO_2-rich phase.

Izvorni jezik
Engleski

Znanstvena područja
Kemijsko inženjerstvo

POVEZANOST RADA