Naslov
Size distribution of spray atomised aluminium alloy powders produced during linear atomization

Autori
Gorynin, N. L. ; Nefedov, F. K. ; Mamuzić, Ilija

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni

Izvornik
Summaries of lectures of the 10^th international symposium of Croatian Metallurgical Society SHMD '2012 : Materials and Metallurgy, published in Metalurgija 51 (2012) 3 / Mamuzić, Ilija - Zagreb : Hrvatsko metalurško društvo, 2012, 389-389

Skup
10^th international symposium of Croatian Metallurgical Society SHMD '2012 : Materials and Metallurgy

Mjesto i datum
Šibenik, Hrvatska, 17.06.2012. - 21.06.2012

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
aluminium alloy; linear atomization

Sažetak
In the present study, the influence of operating variables, such as atomising gas pressure and linear gas atomiser slit width, on the mass median diameter were investigated for linear spray atomization and deposition of aluminium alloy (Al-1.2Mn-0.6Si-0.7Fe00.15Cu, wt.%). In addition, the influence of atomising gas pressure on the averaged liquid mass flowrate was studied. The results indicate that the averaged liquid mass flowrate increases linearly with the atomising gas pressure differential over the range 260–380 kPa, suggesting that an aspiration effect is present.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija

POVEZANOST RADA