Pregled bibliografske jedinice broj: 542085
Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method
Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method // Strojarstvo, 53 (2011), 4; 243-248 (međunarodna recenzija, članak, znanstveni)
CROSBI ID: 542085 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method
Autori
Bajić, Dražen ; Jozić, Sonja ; Celent, Luka
Izvornik
Strojarstvo (0562-1887) 53
(2011), 4;
243-248
Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni
Ključne riječi
face milling; cutting forces; design of experiments; regression analysis; Taguchi method
Sažetak
This paper presents a study of the influence of cutting conditions on the cutting force components during face milling of steel 42CrMo4. Two experimental plans, rotatable central composite design and the Taguchi method with orthogonal arrays and signal-to-noise ratio, have been designed and performed on controlled machining with corresponding cutting conditions. Equations for the cutting force components, as a functions of cutting parameters, have been obtained by means of regression analysis. The Taguchi method has been used to analyse impact of cutting parameters on the cutting force components and to find optimal level of the cutting parameters. The comparison of results obtained by means of the rotatable central composite design and the Taguchi method was performed.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
POVEZANOST RADA
Projekti:
023-0692976-1742 - Istraživanje visokobrzinske obrade materijala (Bajić, Dražen, MZOS ) ( CroRIS)
Ustanove:
Fakultet elektrotehnike, strojarstva i brodogradnje, Split
Citiraj ovu publikaciju:
Časopis indeksira:
- Scopus
