Naslov
Application of the ΔK, ΔJ and ΔCTOD Parameters in Fatigue Crack Growth Modelling

Autori
Božić, Željko ; Mlikota, Marijo ; Schmauder, Siegfried

Izvornik
Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku (1330-3651) 18 (2011), 3; 459-466

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, pregledni rad, znanstveni

Ključne riječi
CTOD; EPFM; fatigue crack growth; LEFM; J-integral

Sažetak
This paper presents the developed fatigue crack growth models based on parameters ΔK, ΔJ-integral and ΔCTOD determined by using linear elastic and elastic plastic FE analysis. The fatigue crack growth threshold values of the considered crack growth driving force parameters, below which crack propagation does not occur, were taken into account. Fatigue crack growth tests with constant load amplitude were carried out on a centrally cracked plate specimen until collapse occurred. The tests were performed on mild steel specimens at room temperature in laboratory air, at a loading frequency of 5 Hz. For the analyzed specimen, the calculated ΔJ-integral range values obtained by linear elastic analysis, ΔJle, and the elastic-plastic values, ΔJep, were close at lower crack growth rates. As the crack length increases the ΔJep values became higher as compared with the linear elastic values, ΔJle, This indicates that small scale yielding conditions prevailed only for smaller crack lengths. The models based on the EPFM parameters ΔJep and ΔCTOD provide better agreement with experimental results for higher crack growth rates, compared with the models based on the LEFM parameters ΔK and ΔJle.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA