Naslov
Some Considerations on a Molding Simulation for a Polyethylene Product

Autori
Gregov, Goran ; Žic, Samir ; Kršulja, Marko ; Barišić, Branimir ; Kudlaček, Jan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
International Conference on Innovative Technologies IN-TECH / Kudlaček, Jan ; Car, Zlatan ; Barišić, Branimir ; Pepelnjak, Tomaž ; Pakosta, Michal ; Kršulja, Marko - Prag : Tisk AS Jaroměř, 2011, 790-793

ISBN
978-80-904502-6-4

Skup
International Conference on Innovative Technologies IN-TECH

Mjesto i datum
Bratislava, Slovačka, 01.09.2011. - 03.09.2011

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
injection molding; 3D design; polyethylene; mold; plastic

Sažetak
A number of considerations must be taken into account while designing a plastic product. Use of simulations facilitates creation of defect free products while taking in consideration its final use. In this paper an investigation of filling time, cycle and considerations of design geometry, material flow, mold and product cooling are discussed. An example of a tap used as insert into chairs with tube frame is shown and its production analyzed. Cycle times are tested in real production and results discussed. Mold flow simulation is used for prediction and control of runner balancing.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija, Računarstvo, Strojarstvo

POVEZANOST RADA