Pregled bibliografske jedinice broj: 529242
Modified Hydraulic Bulging in Determination of Flow stress Curve
Modified Hydraulic Bulging in Determination of Flow stress Curve // Special Edition: 10th International Conference on Technology of Plasticity / Gerhadr, Hirt ; A. Erman, Tekkaya (ur.).
Aachen: Stahleisen Communications, 2011. str. 720-725 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 529242 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Modified Hydraulic Bulging in Determination of Flow stress Curve
Autori
Keran, Zdenka ; Math, Miljenko ; Piljek, Petar
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Special Edition: 10th International Conference on Technology of Plasticity
/ Gerhadr, Hirt ; A. Erman, Tekkaya - Aachen : Stahleisen Communications, 2011, 720-725
ISBN
978-3-514-00784-0
Skup
International Conference on Technology of Plasticity
Mjesto i datum
Aachen, Njemačka, 25.10.2011. - 30.10.2011
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
modified hydraulic bulging; flow curve; hydroforming
Sažetak
The objective of this study is an original method of the stress strain diagram acquisition named modified hydraulic bulging on the sphere. The method has been derived from the hydraulic bulging test. The flow stress-true strain curves were established for aluminium sheet on the experimental apparatus designed for both methods. For the purpose of comparing the two researched methods, appropriate expressions, i.e. expressions for kinematics and particular equivalent stresses were derived. In both cases, the assumption of the membrane stress state was used and the flow rule was determined, which was necessary for establishing the flow stress-true strain curves. The comparison between the used methods has shown the advantages of the new modified method. New method allows more accurate determination of membrane state of stress in the deforming material. Assumption on the bulge geometry is no longer needed since modification, using sphere as an obstacle, determines the radius of curvature needed in acquisition of membrane stress. Performing modified hydraulic bulging upon just one test specimen yields three points of stress-strain curve. Experimentally obtained points have different strains, covering different areas of strain ; small, medium and large deformations, within a single experiment.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
POVEZANOST RADA
Projekti:
120-1201787-1786 - CAM tehnologije i modeliranje u oblikovanju deformiranjem i mikrooblikovanju (Math, Miljenko, MZOS ) ( CroRIS)
Ustanove:
Fakultet strojarstva i brodogradnje, Zagreb