Naslov
APPLICATION OF TAGUCHI METHOD IN THE OPTIMIZATION OF FACE MILLING PARAMETERS

Autori
Sekulić, Milenko ; Hadžistević, Miodrag ; Jurković, Zoran ; Kovač, Pavel ; Gostimirović, Marin

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
34th INTERNATIONAL CONFERENCE - ICPE 2011 / TRAJANOVIĆ, Miroslav - Niš : University of Niš, Faculty of Mechanical Engineering, 2011, 57-60

ISBN
9788660550196

Skup
34th INTERNATIONAL CONFERENCE ON PRODUCTION ENGINEERING

Mjesto i datum
Niš, Srbija, 28.09.2011. - 30.09.2011

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Taguchi method; face milling; cutting force

Sažetak
This paper examines the influence of cutting parameters on cutting forces in face milling when machining hardened steel Č3840 (EN 90MnCrV8). The milling parameters evaluated are cutting speed, feed rate and depth of cut. The experiments have been carried out in accordance with a Taguchi method. An orthogonal array, signal-to-noise (S/N) ratio and analysis of variance (ANOVA) are employed to analyze the effect of these milling parameters. The analysis of the results shows that the optimal combination for low cutting force are high cutting speed, low feed rate and low depth of cut. The study shows that the Taguchi method is suitable to solve the stated problem with minimum number of trials as compared with a full factorial design.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA