Naslov
Aluminium bronze as an "insulator"

Autori
Marušić, Vlatko ; Rosandić, Željko ; Rozing, Goran

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
PROCEEDINGS OF THE 11th INTERNATIONAL CONFERENCE "RESEARCH AND DEVELOPMENT IN MECHANICAL INDUSTRY" RaDMI 2011, VOL. 1 / Dašić, Predrag V. - Vrnjačka Banja : SaTCIP (Scientific and Technical Center for Intellectual Property), 2011, 71-79

ISBN
978-86-6075-027-5

Skup
11th INTERNATIONAL CONFERENCE "RESEARCH AND DEVELOPMENT IN MECHANICAL INDUSTRY" RaDMI 2011

Mjesto i datum
Soko Banja, Srbija, 15.09.2011. - 18.09.2011

Vrsta sudjelovanja
Pozvano predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
aluminium bronze ; cladding ; hardness ; metallographic analysis

Sažetak
The characteristics of aluminium bronze deposited on the base metal of the tooling for deep drawing are shown in this paper. This tooling is used in the forming of CrNi stainless steel sheets. During processing, the particles of steel material of tooling must be prevented from penetrating the surface layer of workpiece. They must be “insulated” from each other. The deposit made for this testing was the aluminium bronze/steel compound. CuAl-A3 alloy was deposited on St 52-3 N base metal by the cladding procedure. Measuring of dimensions, metallographic analysis and hardness testing were performed before and after the heat treatment, and after compressing of the test samples. It was determined that the chosen parameters of cladding can give good “insulation” layer between the base metal of tooling and the workpiece.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA