Naslov
Analysis of cutting forces in turning of workpiece with a slot

Autori
Baškarić, Tomislav ; Damjanović, Darko ; Duspara, Miroslav ; Kozak, Dražan ; Ergić, Todor ; Stoić, Antun

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
10th Youth Symposium on Experimental Solid Mechanics / Martin Stockmann, Jens Kretzschmar - Chemnitz : Chemnitz University of Technology, Institute of Mechanics and Thermodynamics, Department of Solid Mechanics, 2011, 37-38

ISBN
978-3-941003-34-7

Skup
10th Youth Symposium on Experimental Solid Mechanics

Mjesto i datum
Chemnitz, Njemačka, 25.05.2011. - 28.05.2011

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Cutting forces in turning; the workpiece with a rectangular slot; cutting parameters

Sažetak
Cutting forces in case of turning are analysed in this paper. In the first case, circular workpiece without the slot is analysed. Further, circular workpiece with a square slot is analysed. Obtained measurement results are compared with each other. Following processing parameters were varied: radial depth of cutting, cutting speed and feed rate. Analysis of cutting forces in case of turning the workpiece with a slot is analogous to the cutting forces in milling when the mill is in contact with the workpiece. Based on the measurement results, optimal processing parameters for turning the workpiece with a slot are determined.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA