Naslov
Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method

Autori
Bajić, Dražen ; Jozić, Sonja ; Celent, Luka

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Mechanical technologies and structural materials 2010 / Dr.sc. Dražen Živković - Split : Hrvatsko društvo za strojarske tehnologije (HDST), 2010, 52-59

Skup
1st International Conference MTSM 2010

Mjesto i datum
Split, Hrvatska, 21.10.2010. - 22.10.2010

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
face milling; cutting forces; design of experiments; regression analysis; Taguchy method.

Sažetak
This paper presents a study of the influence of cutting conditions on the cutting force components during face milling of steel 42CrMo4. Two experimental plans, rotatable central composite design and the Taguchi method with orthogonal arrays and signal-to-noise ratio, have been designed and performed on controlled machining with corresponding cutting conditions. Equations for the cutting force components, as a functions of cutting parameters, have been obtained by means of regression analysis. The Taguchi method has been used to analyse impact of cutting parameters on the cutting force components and to find optimal level of the cutting parameters. The comparison of results obtained by means of the rotatable central composite design and the Taguchi method was performed.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA