Naslov
Design of experiment's application in the optimization of milling process

Autori
Bajić, Dražen ; Jozić, Sonja ; Podrug, Srdjan

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni

Izvornik
Metallurgy-Metalurgija / Mamuzić, Ilija - Zagreb : Hrvatsko metalurško društvo, 2010, 201-201

Skup
9th International Symposium of Croatian Metallurggical Cociety "Materials and Metallurgy"

Mjesto i datum
Šibenik, Hrvatska, 20.06.2010. - 24.06.2010

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
face milling; surface roughness; design of experiments; regression analysis; Taguchi method

Sažetak
This paper examines the influence of cutting parameters on surface roughness of steel workpiece. The experiments have been carried out in accordance with a design of experiments (DOE). Equation for the surface roughness, as a function of cutting parameters, has been obtained by means of regression analysis. To obtain the minimal value of surface roughness, the equation optimizing was performed by using partial derivations and solving system of equations. The Taguchi method, with orthogonal arrays and signal to noise ratio, has been used to analyse impact of various cutting parameters on surface roughness and to find optimal levels of the cutting parameters. The comparison of results obtained by means of the response surface method and the Taguchi method was performed.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA