Frequency Range Estimation for the Turning Process

Stoić, Antun; Samardžić, Ivan; Kozak, Dražan; Duspara, Miroslav

Pregled bibliografske jedinice broj: 422624

Frequency Range Estimation for the Turning Process

Stoić, Antun; Samardžić, Ivan; Kozak, Dražan; Duspara, Miroslav

Frequency Range Estimation for the Turning Process // Manufacturing engineering Vyrobne Inžinierstvo, VII (2009), 3; 17-20 (podatak o recenziji nije dostupan, članak, znanstveni)

CROSBI ID: 422624 Za ispravke kontaktirajte CROSBI podršku putem web obrasca

Naslov
Frequency Range Estimation for the Turning Process

Autori
Stoić, Antun ; Samardžić, Ivan ; Kozak, Dražan ; Duspara, Miroslav

Izvornik
Manufacturing engineering Vyrobne Inžinierstvo (1335-7972) VII (2009), 3; 17-20

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Turning; FFT; Chip forms; Mechanical properties; Dynamic properties

Sažetak
Turning is the continuous process of separation of materials, but the values of individual components of force are variable over time. To determine the frequency of the variation of individual component, the measured data (cutting force component) has to be translate into Fourier row (using FFT). Linderberg and Lindstrom [1] have noticed that the maximum natural frequency of any component in the system tool-machine-processed is below 1 kHz. Frequency of creating of a lamella does not depend on the stiffness of machine, because natural frequencies of individual parts of machine tool are quite below this frequency. By performing of monitoring of the cutting process in the frequency domain, one can found all the changes that are happening in each of the participants or processes, and thus adjust the parameters of the cutting process. Increasing of the cutting speed influences the frequency range to increase.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA

Projekti:
152-0000000-3309 - Suvremene tehnike obrade rezanjem u proizvodnji prihvatljivoj okolišu (Stoić, Antun, MZOS ) ( CroRIS)
152-1201910-1909 - Analiza i procjena loma konstrukcija iz anizotropnih materijala (Kozak, Dražan, MZOS ) ( CroRIS)
152-1521473-1474 - Napredni postupci izravne izradbe polimernih proizvoda (Raos, Pero, MZOS ) ( CroRIS)
152-1521473-1476 - Suvremene tehnologije spajanja lakih strojarskih konstrukcija (Samardžić, Ivan, MZOS ) ( CroRIS)