Pregled bibliografske jedinice broj: 42042
Comparison of theoretical roughness in turning and orthogonal turn-milling
Comparison of theoretical roughness in turning and orthogonal turn-milling // CIM2000 / Cebalo, Roko ; Schulz, Herbert (ur.).
Zagreb: Hrvatska udruga proizvodnog strojarstva (HUPS), 2000. str. 29-37 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 42042 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Comparison of theoretical roughness in turning
and orthogonal turn-milling
Autori
Motika, Romano ; Škorić, Stephan ; Ciglar, Damir
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
CIM2000
/ Cebalo, Roko ; Schulz, Herbert - Zagreb : Hrvatska udruga proizvodnog strojarstva (HUPS), 2000, 29-37
Skup
Computer Integrated Manufacturing and High Speed Machining
Mjesto i datum
Korčula, Hrvatska; Lumbarda, Hrvatska, 08.06.2000. - 09.06.2000
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
turning; orthogonal turn-milling; theoretical surface roughness
Sažetak
Orthogonal turn-milling is replacing turning because of its advantages such as: higher productivity of the procedure, shape of chip, and longer tool life. By using high speeds the centrifugal forces of workpiece clamping devices during turning represent a significant limitation, thus rendering turn-milling an even greater importance. Therefore, the procedure deserves to be systemically analysed and compared to turning. The analysis and comparison of the theoretical roughness of the machined surfaces also gives advantage to orthogonal turn-milling. This provides knowledge and guidelines for further experimental research.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
