Naslov
Influence of Drill Geometry and Chip Shape on the Quality of Drilled Holle in Composite Material

Autori
Koboević, Nikša ; Mišković, Ante

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
12th International Research/Expert Conference "Trends in the Development of Machinery and associated technology" TMT 2008, Istanbul, Turkey / Ekinović, Sabahudin ; Yalcin, Senay ; Vivancos, Calvet Joan - Istanbul : Faculty of Mechanical Engineering in Zenica, University of Zenica, 2008, 1301-1304

ISBN
978-9958-617-41-6

Skup
Trends in the Development of Machinery and associated technology" TMT 2008

Mjesto i datum
Istanbul, Turska, 26.08.2008. - 30.08.2008

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Drilling; Composite materials; Hole quality

Sažetak
The drilling composite materials is a very common and important process used in the process of assembling of composite structures. In the process of composite material drilling the following errors happen: delamination, fraying, edge chipping, spalling, surface roughness and dimensional errors. The paper presents an experimental investigation of drilling of carbon and aramide reinforced composite material. In this paper it is explained how hole errors depend on drill geometry and the shape of the removed material chips.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo, Tehnologija prometa i transport

POVEZANOST RADA