Naslov
Built-up Material in Machining of Light Metals

Autori
Tomac, Nikola

Vrsta, podvrsta i kategorija knjige
Autorske knjige, ostalo, znanstvena

Izdavač
Department of Production Engineering, Norwegian Institute for Technology

Grad
Trondheim

Godina
1993

Stranica
160

ISBN
82-7119-546-8

Ključne riječi
production engineering; machining; magnesium

Sažetak
When magnesium alloys are machined with carbide tools at high cutting speed, workpiece material may build-up on the tool, accompanied by a sharp increase in surface roughness and tool forces. It was shown through cutting experiments that with the use of a water based cutting fluid the flank build-up problems were completely eliminated within the actual cutting speed range. A part of this work shows that magnesium alloys can be machined with the polycristalline diamond (PCD) tool at very high cutting speeds without the FBU formation and with less fire hazard.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA