Naslov
Reduction of dustiness in sawing wood by universal circular saw

Autori
Očkajová, Alena ; Beljo Lučić, Ružica ; Čavlović, Ankica ; Tereňová, Jana

Izvornik
Drvna industrija : znanstveno-stručni časopis za pitanja drvne tehnologije (0012-6772) 57 (2006), 3; 119-126

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, prethodno priopćenje, znanstveni

Ključne riječi
wood dust; sawing; various type of saw blade; granularity

Sažetak
The aim of this paper is a comparison of particle size distribution of sawdust in longitudinal sawing of wood by the universal circular saw when using two saw blades with different types of teeth. Experiments were carried out by the use of a universal circular saw, at the cutting speed of v = 50 m• s-1 and feed speed of vf = 16 m• min-1. A universal saw blade with triangular asymmetric spring setting teeth K1 was used as a tool, as well as a saw blade with tipped swaged teeth K2. Specimens were used of spruce, beech and meranti wood with moisture content from 8 to 10 %, species otherwise typical of the production of Euro windows. Granulometric analysis of produced sawdust was carried out by a sieve machine Fritch, with the set of sieves whose mesh gauge were as follows 1.0, 0.5, 0.355, 0.1, 0.05 and the bottom. Each specimen was meshed for 15 minutes and three specimens were meshed for each variant. The results show that larger chips were produced with the use of the saw blade K2 - the proportion of 1 mm mesh, where the difference in using these two types of blades was up to 25 % - meranti. From the viewpoint of airborne particles, it should be emphasised that with all three species of wood, the production of particles smaller than 100 μ m (0.05 and bottom mach)was twice lower when sawing was carried out with the saw blade K2 than with the saw blade K1. Even though the share of fine fraction was not considerable in the obtained samples, it can be stated that these amounts are also hazardous for the work environment and therefore attention should be drawn to the results of these experimental measurements, as it is posible to affect the proportion of fine fraction smaller than 100 μ m by an adequate choice of tool.

Izvorni jezik
Engleski

Znanstvena područja
Šumarstvo

POVEZANOST RADA