Pregled bibliografske jedinice broj: 28811
Surface Roughness of the Surface Milled with Ball Nose End Mills
Surface Roughness of the Surface Milled with Ball Nose End Mills // Proceedings of the 9th International Symposium of DAAAM / Katalinić, Branko (ur.).
Beč: DAAAM International Vienna, 1998. str. 471-472 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 28811 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Surface Roughness of the Surface Milled with Ball Nose End Mills
Autori
Udiljak, Toma ; Motika, Romano
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Proceedings of the 9th International Symposium of DAAAM
/ Katalinić, Branko - Beč : DAAAM International Vienna, 1998, 471-472
Skup
9th International DAAAM Symposium
Mjesto i datum
Cluj-Napoca, Rumunjska, 22.10.1998. - 24.10.1998
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
high speed cutting; surface roughness; modeling
Sažetak
It seeems that high speed machining (HSM) is a key driving force for the development in the domain of cutting theory and machine tool design and control in this decade. The increase of cutting speed and feed rate by factor of 5-10 allows reduction of machine time and increase of surface quality. This paper presents the results of invetigation of infulence of the cutting data and position of cuuting tool axes in regards to the feed rate direction on the surface roughness. The obtained results proves that better surface roughness should be expected when angle between cutting tool axes and machined surface is different then 90, what is of high importance when comparing 3-axes and 5-axes machine tools, same as when preparing cutting tool path.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
