Naslov
Rheological Properties and Morphology of High-Impact Polystyrene and Styrene/Ethylene/Butylene/Styrene Blends

Autori
Rek, Vesna ; Holjevac Grgurić, Tamara ; Jelčić, Želimir

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni

Izvornik
Materials tribology processing / - Zagreb : Hrvatsko društvo za materijale i tribologiju (HDMT), 2003

Skup
MATRIB 2003

Mjesto i datum
Vela Luka, Hrvatska, 26.06.2003. - 28.06.2003

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
high-impact polystyrene; SEBS block copolymer; rheological properties; processing; master curve; morphology

Sažetak
The multiphases polymer systems, thermoplastic materials modified with thermoplastic elastomers are intensively studied to developed the new engineering materials with new or improved properties. Blends of high-impact polystyrene, PS-HI, and styrene/ethylene/butylene/styrene block copolymer, SEBS, are investigated to determine the effect of rubber on the polymer properties. In this paper the processing behaviour of PS-HI+SEBS blends are analysed and primary as well as secondary viscoelastic functions are obtained. Rheological behaviour of the blends during processing was followed by measuring the torque, output and melt pressure in the twin extruder Haake Record 90. The viscoelastic functions, storage modulus and loss modulus and loss tangent were obtained by Dynamic Mechanical Analyser 983. The creep relaxation measurements were obtained in creep fatique regime at temperatures 25, 35, 45, 55 and 65 °C. Processing and viscoelastic behaviour was correlated with the morphology of the blends studied by scanning electron microscope. The results show that rheological behaviour in blends processability as well as their viscoelastic functions and their morphology depend on the copolymers and blends compositions, number of phases and phase content. The influence of SEBS content on the increase of the aparent viscosity is observed above 40 % weight of SEBS copolymer in the blends. The torque value of the blends is not significant increase with SEBS content below 70 % weight with respect to neat PSHI. All samples have a single Tg of the hard phase. At the constant load the creep values of all examined samples increase and those of the creep modulus decrease over a period of time. The master curves were created for the reference temperature 25 °C. A phase separate microstructure is more pronounced in the PSHI+SEBS blends. The rise in fracture energy with SEBS introduction occurs.

Izvorni jezik
Engleski

Znanstvena područja
Kemijsko inženjerstvo

POVEZANOST RADA