Pregled bibliografske jedinice broj: 223467
Average Temperature on Contact Tool-Workpiece by Milling
Average Temperature on Contact Tool-Workpiece by Milling // Proceeding of 10th International Scientific Conference on Production Engineering / Cebalo, Roko ; Schulz, Herbert (ur.).
Zagreb: Hrvatska udruga proizvodnog strojarstva (HUPS), 2005. (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), stručni)
CROSBI ID: 223467 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Average Temperature on Contact Tool-Workpiece by Milling
Autori
Cebalo, Roko ; Stoić, Antun ; Jurjević, Mate
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), stručni
Izvornik
Proceeding of 10th International Scientific Conference on Production Engineering
/ Cebalo, Roko ; Schulz, Herbert - Zagreb : Hrvatska udruga proizvodnog strojarstva (HUPS), 2005
Skup
10th International Scientific Conference on Production Engineeringh - CIM 2005
Mjesto i datum
Lumbarda, Hrvatska, 15.06.2005. - 17.06.2005
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
temperature; cutting; milling; lip angle
Sažetak
The heat generating along the contact of milling cutter and workpiece has an influence on milling process. Average temperature on contact is influenced with material of workpiece and with cutting conditions. There are a lot of influencing parameters wich increase this temperature. The most significant influence arise from angle of milling edge and cutting speed. Test are conducted with HSS milling cutter on heat treated alloyed steel Č7432 both on up-cut and down-cut milling. Results of testing the influence of lip angle and other parameters on average temperature on milling cutter-workpiece contact are shown in this paper.
Izvorni jezik
Engleski
Znanstvena područja
Tehnologija prometa i transport
