Pregled bibliografske jedinice broj: 211629
Spot potential profiles and pitting liability of thermally oxidised stainless steel
Spot potential profiles and pitting liability of thermally oxidised stainless steel // Corrosion and protection in high technology era
Peking, 2005. (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 211629 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Spot potential profiles and pitting liability of thermally oxidised stainless steel
Autori
Esih, Ivan ; Alar, Vesna ; Juraga, Ivan
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Corrosion and protection in high technology era
/ - Peking, 2005
Skup
16th International corrosion congress
Mjesto i datum
Peking, Kina, 19.09.2005. - 24.09.2005
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
Stainless steel; thermal oxidation; spot potentials; pitting
Sažetak
Effect of thermal oxidation on the behavior of stainless steel (SS) in FeCl3-solution was investigated. Rectangular sheet specimens of SS AISI 316L with observed area S=90 cm2 were immersed into the solution (a) in the initial state, (b) after heating in air isothermally at 200, 400, 600, 800 and 1000 °C respectively, or in temperature gradient between 1100 and 100 °C, and (c) after heating and subsequent removal of thermal oxides in HNO3/HF-mixture. Spot potential profiles of specimens were taken up using a device with graphite counter-electrode by measuring potential differences between specimen and graphite, Δ E. The presence of thermal oxides enhances profile non-uniformity that corresponds to increased electrochemical heterogeneity of SS surface. The removal of thermal oxides decreases profile non-uniformity, but it does not restore the initial degree of homogeneity. The prolonged exposure to FeCl3-solution provokes pitting corrosion of specimens heated isothermally at 400 °C and above it or heated in temperature gradient. On such specimens pits number, np, their depths, hp, and orifice areas, Sp, were determined. Maximum pits density, np/S, is observed after heating at 600 °C. Average pit depths, hp, and orifice areas, Sp, are affected by heating conditions, too. The removal of thermal oxides influences the values of np/S, hp, and Sp, considerably. Possible causes of the observed phenomena are discussed.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
