Naslov
Effectivness of composite polymerization with LEDs of second generation

Autori
Knežević, Alena ; Tarle, Zrinka ; Negovetić Mandić, Višnja ; Pandurić, Vlatko ; Prskalo, Katica ; Šutalo, Jozo

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni

Izvornik
Continental European and Scandinavian Divisions Meeting. U: Journal of Dental Research.2005. / - , 2005, 115-116

Skup
2005 Continental European and Scandinavian Divisions Meeting

Mjesto i datum
Amsterdam, Nizozemska, 2005

Vrsta sudjelovanja
Poster

Vrsta recenzije
Podatak o recenziji nije dostupan

Ključne riječi
degree of conversion ; composite resins ; curing lights

Sažetak
Objectives: The first generation of LED light curing unit (LCU) had a relatively low power output, in contrast to second generation of LEDs which have a greater power output and shorter curing time, but also different spectral distribution. The aim of this study was to compare a degree of conversion (DC) during polymerization of composite resins with two LED LCU of second generation. Methods: For measuring the DC, five samples were prepared for Tetric Ceram (TC) (Vivadent, Schaan, Liechtenstein) and Filtek P60 (P60)(ESPE, Seefeld, Germany) each. Unpolymerized composite sample was placed between two Mylar foils and pressed at 107 Pa to 0.1 mm thickness. For surface DC measurements, light source Bluephase (600 mW/cm2 first 5th sec, 1100 mW/cm2 to the end of illumination) and Bluephase C5 (500 mW/cm2) (both LCU from Vivadent, Schaan, Liechtenstein) were placed on the upper foil of the unpolymerized sample and polymerized (20 sec for TC and P60 with Bluephase, and 40 sec for TC and 20 sec for P60 with Bluephase C5). For measurements at 2 mm depth, overlayers 2 mm thick were made for each material. Light source was placed on the overlayer and polymerized in the same way as when measuring surface conversion. For determining DC, FTIR spectra of polymerized (P) and unpolymerized (U) samples were recorded using Perkin-Elmer Spectrometer (Beaconsfield, Bucks, UK) and calculated according to Rueggebergs formula: % DC = (1-P/U) x 100% Results: The highest DC was reached in case of polymerization with Bluephase for both materials tested on the surface and 2 mm depth. There is no significant difference between polymerization on the surface and 2 mm depth in case of illumination with both LCU, but there is signifficant difference between two tested materials in case of polymerization with both LCU on 2 mm depth. Conclusion: LCU with grater light intensity will enhance better polymerization but the difference in DC between composite materials may be influenced with different concentration of photoinitiators and co- initiators which spectrum lies outside the spectrum emitted from LCU tested.

Izvorni jezik
Engleski

Znanstvena područja
Dentalna medicina

Napomena
Sažeci sa kongresa dostupni na mrežnoj stranici IADR
u Abstracts Archives

POVEZANOST RADA