Naslov
Effects of fine particles on some characteristics of granular base courses

Autori
Babić, Branimir ; Prager, Andrija ; Rukavina, Tatjana

Izvornik
Materials and structures (1359-5997) 33 (2000), 231; 419-424

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
granular stone material; fine particles; bearing capacity; permeability

Sažetak
The paper presents the results of a scientific research program focused on determining the effect of the fine particles content in granular stone materials on particular properties of unstabilized base course. Grain-size distribution of a granular system was within the defined limits, and the percentage of fine particles (<0.02 mm in diameter) ranged from 0 to 10% by mass. Two types of fine particles were tested, those of stone and clay origin. The specimens were compacted using five energy levels. Used lab. equipment was in compliance with the requirements of German (DIN) and Swiss (SNW) standards. The following characteristics were tested: - bearing capacity (CBR test) at optimum moisture content and after one freezing/thawing cycle - permeability (coefficient of permeability k). The opbtained results were statisticaly analyzed and graphicaly presented. The most inportant outputs are: (a) Bearing capacity - within the research limits of 0 to 10% by mass, fine stone particles have positive effect and the bearing capacity increases, - fine clay particles content not higher than 5% by mass is acceptable ; for higher percentages, the bearing capacity decreases. (b) Permeability - for fine stone particles content below 5% by mass permeability is still satisfactory ; however, even a very small percentage of fine clay particles has an adverse impact on permeability. The conclusions are related to the tested materials and should be used as starting point for further investigation.

Izvorni jezik
Engleski

Znanstvena područja
Građevinarstvo

POVEZANOST RADA