Pregled bibliografske jedinice broj: 19506
Scanning electron microscopy analysis of low alloy steels
Scanning electron microscopy analysis of low alloy steels // Proceedings 1st Congress of the Croatian Society for Electron Microscopy / Vranešić Djuro (ur.).
Zagreb: Hrvatsko društvo za elektronsku mikroskopiju, 1999. str. 76-77 (poster, domaća recenzija, cjeloviti rad (in extenso), stručni)
CROSBI ID: 19506 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Scanning electron microscopy analysis of low alloy steels
Autori
Gojić, Mirko ; Matković, Prosper ; Kosec Ladislav ;
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), stručni
Izvornik
Proceedings 1st Congress of the Croatian Society for Electron Microscopy
/ Vranešić Djuro - Zagreb : Hrvatsko društvo za elektronsku mikroskopiju, 1999, 76-77
Skup
1st Congress of the Croatian Society for Electron Microscopy with International participation
Mjesto i datum
Zagreb, Hrvatska, 13.05.1999. - 16.05.1999
Vrsta sudjelovanja
Poster
Vrsta recenzije
Domaća recenzija
Ključne riječi
Heat treatment; low alloy steel; microstructure; microscopy
Sažetak
The aim of the present paper is to determine of microstructures on two low alloyed steels (low alloy Cr and Cr-Mo steels)at cooling rate of 0.05K/s using dilatometric method. For microstructural examination of steels was used scanning electron microscopy (SEM). After heat treatment hardness measurements were made using Vickers method (HV). On the basis dilatometric, SEM and hardness analysis of steels concluded that at cooling rate of 0.05K/s only ferrite-pearlite and ferrite-pearlite-bainite transformations appeared.
Izvorni jezik
Engleski
Znanstvena područja
Metalurgija
POVEZANOST RADA
