Pregled bibliografske jedinice broj: 134300
Calculation of Surface Roughness by Milling with Cilindrical Cutter
Calculation of Surface Roughness by Milling with Cilindrical Cutter // Research Papers Faculty of Materials Scinece and Technology, Slovak University of Technology in Trnava, 13 (2002), 33-38 (podatak o recenziji nije dostupan, članak, znanstveni)
CROSBI ID: 134300 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Calculation of Surface Roughness by Milling with Cilindrical Cutter
Autori
Lipa, Zdenek ; Peterka, Josef ; Udiljak, Toma
Izvornik
Research Papers Faculty of Materials Scinece and Technology, Slovak University of Technology in Trnava (1336-1589) 13
(2002);
33-38
Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni
Ključne riječi
roughness; milling; milling with cylindrical cutter
Sažetak
Surface roughness by milling with cylindrical cutter is determined in technical literature, as so as in university textbooks, relatively very infrequently. The problem is usually simplified, so there are introduced simplified relations for calculations of theoretical surface roughness by milling with cylindrical cutters (calculation of parameter Rz ). In this contribution we present improved calcul of not only parameter Rz , but also parameter Ra .
Izvorni jezik
Slo
Znanstvena područja
Strojarstvo
POVEZANOST RADA
Projekti:
0120036
Ustanove:
Fakultet strojarstva i brodogradnje, Zagreb
Profili:
Toma Udiljak
(autor)
