Pregled bibliografske jedinice broj: 1258748
STRENGTH OF CORNER TENON JOINTS MADE FROM THERMO-TREATED WOOD
STRENGTH OF CORNER TENON JOINTS MADE FROM THERMO-TREATED WOOD // PROCEEDINGS OF THE 31ST DAAAM INTERNATIONAL SYMPOSIUM ON INTELLIGENT MANUFACTURING AND AUTOMATION / Katalinic, Branko (ur.).
Beč: DAAAM International Vienna, 2020. str. 137-143 doi:10.2507/31st.daaam.proceedings.018 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 1258748 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
STRENGTH OF CORNER TENON JOINTS MADE
FROM THERMO-TREATED WOOD
Autori
Hajdarevic, Seid ; Obucina, Murco ; Busuladzic, Ibrahim ; Ibrisevic, Alen
Kolaboracija
Faculty of Mechanical Engineering, University of Sarajevo
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
PROCEEDINGS OF THE 31ST DAAAM INTERNATIONAL SYMPOSIUM ON INTELLIGENT MANUFACTURING AND AUTOMATION
/ Katalinic, Branko - Beč : DAAAM International Vienna, 2020, 137-143
ISBN
978-3-902734-29-7
Skup
31ST DAAAM INTERNATIONAL SYMPOSIUM ON INTELLIGENT MANUFACTURING AND AUTOMATION
Mjesto i datum
Mostar, Bosna i Hercegovina, 21.10.2020. - 24.10.2020
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
ash wood ; thermo-treated wood ; tenon joint ; joint strength ; bending strength
Sažetak
This paper investigated the strength of corner tenon joints made from natural ash wood and thermally-modified ash wood. Previously, an analysis of selected physical and mechanical properties of natural and thermal- treated ash wood was performed. The results showed that thermo-treated ash wood in relation to natural ash wood has a remarkable lower wood moisture content, 23% lower bending strength and 25% higher compressive strength parallel to grain. The joints strength (maximal moment), calculated on the basis of measured maximal applied loads (maximal force), were compared for a set of natural ash wood joints and a set of thermo- treated ash wood joints. Results of the tests showed that, for the same test specimen configurations, the maximum force of joints made of natural ash wood was higher than the force values of joints made of thermo-treated ash wood, i.e. the strength of thermo-treated joints has 50% lower value compared to the strength of the natural ash joints. It has been shown that thermal modification changes the technical properties of wood and that therefore thermally modified wood has a remarkable reduced construction quality.
Izvorni jezik
Engleski
Znanstvena područja
Biotehnologija
