Naslov
Cast Iron Parts Obtained in Ceramic Molds Produced by Binder Jetting 3D Printing—Morphological and Mechanical Characterization

Autori
Păcurar, Răzvan ; Berce, Petru ; Nemeş, Ovidiu ; Băilă, Diana-Irinel ; Stan, Dan Sergiu ; Oarcea, Alexandru ; Popişter, Florin ; Borzan, Cristina Miron ; Maricic, Sven ; Legutko, Stanislaw ; Păcurar, Ancuţa

Izvornik
Materials (1996-1944) 14 (2021), 16; 1-22

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
binder jetting ; 3D printing ; iron casting ; gravitational casting ; finite element analysis

Sažetak
Mechanical behavior and characteristics of two different types of materials: cast iron with lamellar graphite EN-GJL-250 and cast iron with spheroidal graphite EN-GJS-400-15 which were cast in ceramic molds using gravitational casting method has considered in this research. The ceramic molds were obtained by 3D printing method. First, a finite element analysis was developed to determine Tresca and von Mises stresses and the deformations of the ceramic molds under an applied pressure of 25 MPa. Samples were produced by gravitational casting using two types of cast iron materials. Mechanical tests were made using samples produced from these two types of materials and microstructure analysis evaluation of fractured zones was realized by scanning electron microscopy. Obtained results were finally used for designing, developing, and producing of one ‘hydraulic block’ of a railway installation by the Benninger Guss company of Switzerland.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA