Naslov
Workpiece oscillations in interrupted turning process

Autori
Ciboci, Dominik ; Duspara, Miroslav ; Horvat, Katarina ; Stoić, Marija ; Stoić, Antun

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, stručni

Izvornik
Proceedings of the 10 th International Scientific and Expert Conference TEAM 2022 / Damjanović, Darko ; Stojšić, Josip ; Mirosavljević, Krunoslav ; Sivrić, Hrvoje - Slavonski Brod : Sveučilište u Slavonskom Brodu, 2022, 25-30

Skup
10th International Scientific and Expert Conference TEAM2022

Mjesto i datum
Slavonski Brod, Hrvatska, 21.09.2022. - 22.09.2022

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
workpiece oscillation, turning, camera recording, cutting parameters

Sažetak
The paper analyses the influence of parameters of interrupted turning process on workpiece oscillations. Alteration of undeformed chip cross section area is obtained on OD turning of slotted shaft as a source of impact on cutting tool and workpiece which could lead to deterioration of workpiece surface quality and dynamic process behaviour. The experiments were carried out on Ck 45 steel with conducting 14 oscillation setups. Measurement results are excluded from the time scale video of analogue sensing micrometre obtained during camera process recording. An analysis of the obtained results shows the influence of processing parameters on oscillations.

Izvorni jezik
Engleski

POVEZANOST RADA