Pregled bibliografske jedinice broj: 1220229
A controlled shaping method through the shrinkage of clay
A controlled shaping method through the shrinkage of clay // Conference Proceedings of IASS/APCS 2022.
Peking, Kina, 2022. str. 3021-3030 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 1220229 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
A controlled shaping method through the shrinkage
of clay
Autori
Gosch, Lukas ; Vašatko, Hana ; Jauk, Julian ; Šamec, Elizabeta ; Zivkovic, Irena ; Stavric, Milena
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Conference Proceedings of IASS/APCS 2022.
/ - , 2022, 3021-3030
Skup
IASS 2022 and 13th APCS
Mjesto i datum
Peking, Kina, 19.09.2022. - 22.09.2022
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
clay ; shrinkage ; shaping method ; lightweight ; paste-based extrusion
Sažetak
This research proposes a new controlled shaping method of thin-walled clay elements. A clay layer isapplied to a carrier material, in order to use the shrinkage behaviour of clay as a shaping agent. Thisshaping process utilises the change of ratio of adhesion forces through the bond of a planar carriermaterial with a wet clay layer on its surface, and cohesion forces in clay, during the drying process.Afterwards, the geometry of clay ranges from single curved to double curved three-dimensional shapesthat open up the possibility of using this method for creating spatial structures. The main advantage ofthe proposed method, as opposed to standard methods of shaping clay elements, is the use of van derWaals` attractive forces formation while drying, as active and controlled actors. This approach allowsthe production of three-dimensional forms without any kind of casting, formwork or elaboratescaffolding while using only secondary force formation during the drying process. The proposed methodis corroborated by a sequence of experiments that evaluate the newly formed material and its reshapingprocess. According to the obtained results, the elements were shaped through the developed method andfired, while the carrier material was removed and reused once the clay elements were fully dried. Thefired elements were assembled in a case study, in order to demonstrate the proposed method.
Izvorni jezik
Engleski
Znanstvena područja
Arhitektura i urbanizam, Građevinarstvo
