Naslov
Influence of Wood Surface Preparation on Roughness, Wettability and Coating Adhesion of Unmodified and Thermally Modified Wood

Autori
Miklečić, Josip ; Lončarić, Andrea ; Veseličić, Nikolina ; Jirouš-Rajković, Vlatka

Izvornik
Drvna industrija : znanstveno-stručni časopis za pitanja drvne tehnologije (0012-6772) 73 (2022), 3; 261-269

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Face milling ; Sanding ; UV irradiation ; Wetting ; Adhesion

Sažetak
In this research, the influence of face milling, sanding and UV irradiation of the hornbeam and ash wood sample on the wetting and adhesion strength of solvent-based and water-borne coating was studied. The adhesion of coatings to substrates is one of the most important parameters for finishing quality and service life of wood coatings, while wetting properties are usually used to assess the quality of surfacing process and could also provide important information on the adhesion ability of coatings. Surface roughness, contact angle of coatings and water as well as adhesion strength of coatings were tested on differently prepared (face milled, sanded and UV irradiated) samples of unmodified and thermally modified ash and hornbeam wood. Surface roughness was measured with stylus-type profilometer over the traverse of 12.5 mm and with a cut-off value of 2.5. Contact angle was measured using the sessile drop method 2 s, 10 s and 30 s after the application of the liquid drop on the sample surface, and adhesion strength was measured according to ASTM D4541. Results showed that sanding of hornbeam and ash wood resulted in the least rough surface compared to the face milled and UV irradiated surface. Contact angles of the water-borne coating were on average three times higher than the contact angles of the solvent-based coating. Sanding the surface of hornbeam and ash samples increased the adhesive strength in relation to the face milled surface, while UV irradiation of the sanded surface decreased the adhesive strength of most samples coated with solvent-based coating.

Izvorni jezik
Engleski

Znanstvena područja
Drvna tehnologija

POVEZANOST RADA