Pregled bibliografske jedinice broj: 11786
Monitoring of Cutting Process by Measuring of Cutting Forces and Momentum
Monitoring of Cutting Process by Measuring of Cutting Forces and Momentum // Proceedings of the 8th International DAAAM Symposium / Katalinić, Branko (ur.).
Dubrovnik, Hrvatska: DAAAM International Vienna, 1997. str. 51-52 (predavanje, međunarodna recenzija, sažetak, znanstveni)
CROSBI ID: 11786 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Monitoring of Cutting Process by Measuring of Cutting Forces and Momentum
Autori
Cebalo, Roko ; Goja, Željko ; Udiljak, Toma
Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, znanstveni
Izvornik
Proceedings of the 8th International DAAAM Symposium
/ Katalinić, Branko - : DAAAM International Vienna, 1997, 51-52
Skup
The 8th International DAAAM Symposium
Mjesto i datum
Dubrovnik, Hrvatska, 23.10.1997. - 25.10.1997
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
high-speed machining; cutting parameters; motorspidle
Sažetak
This paper presents the possibility for measuring technological parameters at high speed machining. A sensor, based on tenzometric principle, for measuring of axial force and momentum has been developed. The sensor is incorporated in workpiece clamping device. Processing of results measured at different cutting parameters enables the estimation of full range of loads that motorspindle is subjected during actual machining. The paper also analysis the significance of measured data for selection of bearing type, same as calculation of bearing, stiffness and vibration of motorspindle.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
