Naslov
Application FEM in plate bending

Autori
Grizelj, Branko ;

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 3rd DAAAM International Conference on Advanced Technologies for Developing Countries / Branko, Katalinić ; Ivica, Veža, Boženko, Bilić - Split : University of Split, DAAAM International Vienna, 2004, 125-130

Skup
3rd DAAAM International Conference on Advanced Technologies for Developing Countries

Mjesto i datum
Split, Hrvatska, 23.06.2004. - 26.06.2004

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Axial-symmetrical bending; Finite element method; Calibration of plate

Sažetak
The paper is concerned with the numeric procedure in axial-symmetrical plate bending. For numeric procedure the finite element method is used. Calibration force is determined when bending force and calibration coefficient are known. The calibration coefficient is determined by experiment. The axial-symmetrical plate bending analysis is restricted to the data used so far in the manufacture of spherical tanks i.e. to deform. up to 1%. To obtain equations for the calculation of force for axial-symmetrical plate bending and displacements during loading procedure and after its removal, data obtained by finite element method were used. The method of least squares was used to interpolate results. Mathematical procedures were used to obtain equations for the calculation of force and displacements, the equations being of use for solving practical problems.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA